Dell Force10 MXL Blade - Page 190

190 | Dynamic Host Configuration Protocol (DHCP)
www.dell.com | support.dell.com
Command
History
excluded-address
Prevent the server from leasing an address or range of addresses in the pool.
Syntax
excluded-address [address | low-address high-address]
Parameters
Command Mode
DHCP
Default
none
Command
History
hardware-address
For manual configurations, specify the client hardware address.
Syntax
hardware-address address
Parameters
Command Mode
DHCP <POOL>
Default
none
Command
History
host
For manual (rather than automatic) configurations, assign a host to a single-address pool.
Syntax
host address
Parameters
Command Mode
DHCP <POOL>
Default
none
Command
History
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
address
Enter a single address to be excluded from the pool.
low-address
Enter the lowest address in a range of addresses to be excluded from the pool.
high-address
Enter the highest address in a range of addresses to be excluded from the pool.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
address
Enter the hardware address of the client.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
address/mask
Enter the host IP address and subnet mask.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module