Dell Force10 MXL Blade - Page 608

608 | Storm Control
www.dell.com | support.dell.com
Parameters
Defaults
none
Command Modes
CONFIGURATION (conf)
Command
History
Usage
Information
Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2 broadcast traffic is treated
as unknown-unicast traffic.
storm-control broadcast (Interface)
Configure the packets per second of broadcast traffic to be limited on the interface.
Syntax
storm-control broadcast [packets_per_second] in
To disable broadcast storm control on the interface, use the no storm-control broadcast
[packets_per_second] in
command.
Parameters
Defaults
none
Command Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
storm-control multicast (Configuration)
Configure the packets per second (pps) of multicast traffic.
Syntax
storm-control multicast [packets_per_second] in
To disable storm-control for multicast traffic into the network, use the no storm-control multicast
[packets_per_second] in command.
Parameters
Defaults
none
Command Modes
CONFIGURATION (conf)
Command
History
packets_per_second
Enter the packets per second of broadcast traffic allowed from the network.
Range: 0 to 33554368.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
packets_per_second
Enter the packets per second of broadcast traffic allowed from the network.
Range: 0 to 33554368
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
packets_per_second
Enter the packets per second of multicast traffic allowed from the network
followed by the keyword
in.
Range: 0 to 33554368
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module