Dell Force10 MXL Blade - Page 196

196 | Dynamic Host Configuration Protocol (DHCP)
www.dell.com | support.dell.com
Command Mode
EXEC Privilege
Default
None
Command
History
debug ip dhcp clients packets
Enable the display of log messages for all DHCP packets sent and received on DHCP client interfaces.
Syntax
debug ip dhcp client packets [interface type slot/port]
Parameters
Command Mode
EXEC Privilege
Default
None
Command
History
release dhcp interface
Release the dynamically-acquired IP address on an Ethernet interface while retaining the DHCP client
configuration on the interface.
Syntax
release dhcp interface type slot/port
Parameters
Command Mode
EXEC Privilege
Default
None.
Command
History
Usage
Information
When you enter the release dhcp command, although the IP address that was dynamically-acquired
from a DHCP server is released from an interface, the ability to acquire a new DHCP server-assigned
address remains in the running configuration for the interface. To acquire a new IP address, enter either
the renew dhcp command at the EXEC privilege level or the ip address dhcp command at the
interface configuration level.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
interface type slot/
port
Display log messages for DHCP packets sent and received on the specified
interface.
For a 10-GigabitEthernet Ethernet interface, enter TenGigabitEthernet followed
by the slot/port numbers; for example, tengigabitethernet 1/3.
For a 40-GigabitEthernet Ethernet interface, enter FortyGigabitEthernet followed
by the slot/port numbers; for example, fortygigabitethernet 0/2.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
interface type slot/
port
For a 10-GigabitEthernet Ethernet interface, enter TenGigabitEthernet followed
by the slot/port numbers; for example, tengigabitethernet 1/3.
For a 40-GigabitEthernet Ethernet interface, enter FortyGigabitEthernet followed
by the slot/port numbers; for example, fortygigabitethernet 0/2.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module