Dell Force10 MXL Blade - Page 651

Uplink Failure Detection (UFD) | 651
Example
Figure 36-3. show uplink-state-group Command Examples
Related
Commands
uplink-state-group
Create an uplink-state group and enable the tracking of upstream links on a switch/router.
Syntax
uplink-state-group group-id
To delete an uplink-state group, use the no uplink-state-group group-id command.
To disable upstream-link tracking without deleting the uplink-state group, use the no enable command
in Uplink-State-Group Configuration mode.
Parameters
Defaults
none
Command Modes
CONFIGURATION
FTOS# show uplink-state-group
Uplink State Group: 1 Status: Enabled, Up
Uplink State Group: 3 Status: Enabled, Up
Uplink State Group: 5 Status: Enabled, Down
Uplink State Group: 6 Status: Enabled, Up
Uplink State Group: 7 Status: Enabled, Up
Uplink State Group: 16 Status: Disabled, Up
FTOS# show uplink-state-group 16
Uplink State Group: 16 Status: Disabled, Up
FTOS#show uplink-state-group detail
(Up): Interface up (Dwn): Interface down (Dis): Interface disabled
Uplink State Group : 1 Status: Enabled, Up
Upstream Interfaces :
Downstream Interfaces :
Uplink State Group : 3 Status: Enabled, Up
Upstream Interfaces : Te 0/46(Up) Te 0/47(Up)
Downstream Interfaces : Te 13/0(Up) Te 13/1(Up) Te 13/3(Up) Te 13/5(Up)
Te 13/6(Up)
Uplink State Group : 5 Status: Enabled, Down
Upstream Interfaces : Te 0/0(Dwn) Te 0/3(Dwn) Te 0/5(Dwn)
Downstream Interfaces : Te 13/2(Dis) Te 13/4(Dis) Te 13/11(Dis) Te 13/12(Dis)
Te 13/13(Dis) Te 13/14(Dis) Te 13/15(Dis)
Uplink State Group : 6 Status: Enabled, Up
Upstream Interfaces :
Downstream Interfaces :
Uplink State Group : 7 Status: Enabled, Up
Upstream Interfaces :
Downstream Interfaces :
Uplink State Group : 16 Status: Disabled, Up
Upstream Interfaces : Te 0/41(Dwn) Po 8(Dwn)
Downstream Interfaces : Te 0/40(Dwn)
show running-config
uplink-state-group
Displays the current configuration of one or more uplink-state groups.
uplink-state-group Creates an uplink-state group and enable the tracking of upstream links.
group-id
Enter the ID number of an uplink-state group. Range: 1-16.