Dell Force10 MXL Blade - Page 669

Virtual Router Redundancy Protocol (VRRP) | 669
Example
Figure 38-2. show vrrp brief Command Example
FTOS>Interface Grp Pri Pre State Master addr Virtual addr(s)
Description------------------------------------------------------------------------------
TenGig 10/37 1 100 Y Master 200.200.200.200 200.200.200.201
TenGig10/37 2 100 Y Master 200.200.200.200 200.200.200.202 200.200.200.203
Description
TenGig10/37 3 100 Y Master 1.1.1.1 1.1.1.2
TenGig10/37 4 100 Y Master 200.200.200.200 200.200.200.206 200.200.200.207 ... short
desc
FTOS>
Table 38-1. show vrrp brief Command Description
Item Description
Interface Lists the interface type, slot and port on which the VRRP group is
configured.
Grp Displays the VRRP group ID.
Pri Displays the priority value assigned to the interface.
If the track command is configured to track that interface and the interface
is disabled, the
cost is subtracted from the priority value assigned to the
interface.
Pre States whether preempt is enabled on the interface.
• Y = Preempt is enabled.
• N = Preempt is not enabled.
State Displays the operational state of the interface by using one of the
following:
• NA/IF (the interface is not available).
• MASTER (the interface associated with the MASTER router).
• BACKUP (the interface associated with the BACKUP router).
Master addr Displays the IP address of the MASTER router.
Virtual addr(s) Displays the virtual IP addresses of the VRRP routers associated with the
interface.