Dell Force10 MXL Blade - Page 373

Multiple Spanning Tree Protocol (MSTP) | 373
Command
History
Related
Commands
disable
Globally disable the multiple spanning tree protocol on the switch.
Syntax
disable
To enable Multiple Spanning Tree Protocol, use the no disable command.
Defaults
MSTP is disabled
Command Modes
MULTIPLE SPANNING TREE
Command
History
Related
Commands
edge-port bpdufilter default
Enable bridge protocol data units (BPDU) filter globally to filter transmission of BPDU on port-fast
enabled interfaces.
Syntax
edge-port bpdufilter default
To disable global bpdu filter default, use the no edge-port bpdufilter default command.
Defaults
Disable
Command Modes
MULTIPLE SPANNING TREE
Command
History
forward-delay
The amount of time the interface waits in the Blocking State and the Learning State before
transitioning to the Forwarding State.
Syntax
forward-delay seconds
To return to the default setting, use the no forward-delay command.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
protocol spanning-tree mstp Enters MULTIPLE SPANNING TREE mode on the switch.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
protocol spanning-tree mstp Enters MULTIPLE SPANNING TREE mode.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module