Dell Force10 MXL Blade - Page 155

Data Center Bridging | 155
Command
History
Usage
Information
To disable TLV transmission, use the no form of the command; for example, no advertise
dcbx-appln-tlv iscsi
.
advertise dcbx-tlv
On a DCBX port with a manual role, configure the PFC and ETS TLVs advertised to DCBX peers.
Syntax
advertise dcbx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-reco | pfc] [ets-conf | ets-reco | pfc]
To remove the advertised ETS TLVs, use the no advertise dcbx-tlv command.
Parameters
Defaults
All PFC and ETS TLVs are advertised.
Command Modes
PROTOCOL LLDP
Command
History
Usage
Information
You can configure the transmission of more than one TLV type at a time; for example: advertise
dcbx-tlv ets-conf ets-reco
.
You can enable ETS recommend TLVs (ets-reco) only if ETS configuration TLVs (ets-conf) are
enabled. To disable TLV transmission, use the no form of the command; for example, no advertise
dcbx-tlv pfc ets-reco
.
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify
the DCBX configuration on a port, use the show interface dcbx detail command.
bandwidth-percentage
Configure the bandwidth percentage allocated to priority traffic in port queues.
Syntax
bandwidth-percentage percentage
To remove the configured bandwidth percentage, use the no bandwidth-percentage command.
Parameters
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
{ets-conf | ets-reco |
pfc}
Enter the PFC and ETS TLVs to be advertised, where:
•
ets-conf: enables the advertisement of ETS configuration TLVs.
•
ets-reco: enables the advertisement of ETS recommend TLVs.
•
pfc: enables the advertisement of PFC TLVs.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
percentage
(Optional) Enter the bandwidth percentage.
The percentage range is 1 to 100% in units of 1%.