Dell Force10 MXL Blade - Page 122

122 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
CONFIGURATION-MAC ACCESS LIST-STANDARD
Command
History
Related
Commands
seq
Assign a sequence number to a deny or permit filter in a MAC access list while creating the filter.
Syntax
seq sequence-number {deny | permit} {any | mac-source-address [mac-source-address-mask]}
[count [byte]]
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION-MAC ACCESS LIST-STANDARD
Command
History
Related
Commands
count (OPTIONAL) Enter the keyword count to count packets processed
by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by
the filter.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
deny Configures a MAC ACL filter to drop packets.
seq Configures a MAC ACL filter with a specified sequence number.
sequence-number
Enter a number between 0 and 65535.
deny Enter the keyword deny to configure a filter to drop packets meeting
this condition.
permit Enter the keyword permit to configure a filter to forward packets
meeting this criteria.
any Enter the keyword any to filter all packets.
mac-source-address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-address-mask
(OPTIONAL) Specify which bits in the MAC address must match. If
no mask is specified, a mask of 00:00:00:00:00:00 is applied (in other
words, the filter allows only MAC addresses that match).
count (OPTIONAL) Enter the keyword count to count packets processed
by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by
the filter.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
deny Configures a filter to drop packets.
permit Configures a filter to forward packets.