14 | CLI Basics
www.dell.com | support.dell.com
Figure 2-3 shows the results of entering ip ? at the prompt.
Figure 2-3. Partial Keyword Example
When entering commands, you can take advantage of the following time saving features:
• The commands are not case sensitive.
• You can enter partial (truncated) command keywords. For example, you can enter int tengig
interface
for the interface tengigabitethernet interface command.
• Use the TAB key to complete keywords in commands.
• Use the up arrow key to display the last enabled command.
• Use either the Backspace key or the Delete key to erase the previous character.
FTOS(conf)#ip ?
access-list Named access-list
control-plane Control plane configuration
dhcp DHCP configuration commands
domain-list Domain name to complete unqualified host name
domain-lookup Enable IP Domain Name System hostname translation
domain-name Define the default domain name
ftp FTP configuration commands
helper-address DHCP relay agent configuration
host Add an entry to the ip hostname table
igmp Internet Group Management Protocol
max-frag-count Max. fragmented packets allowed in IP re-assembly
mroute Multicast routes and counters
msdp Multicast source discovery protocol
multicast-limit Max entries in Multicast TIB
multicast-msdp Enable IP multicast MSDP protocol
multicast-routing Enable IP multicast forwarding
name-server Specify addess of name server to use
pim Protocol Independent Multicast
prefix-list Build a prefix list
radius Interface configuration for RADIUS
route Establish static routes
scp SCP configuration commands
source-route Process packets with source routing header options
ssh SSH configuration commands
tacacs Interface configuration for TACACS+
telnet Specify telnet options
tftp TFTP configuration commands
To Next Page
Loading...
