174 | Data Center Bridging
www.dell.com | support.dell.com
Usage
Information
To clear DCBX frame counters, use the clear dcbx counters interface stack-unit/port command.
Local DCBX Configured
mode
DCBX version configured on the port: CEE, CIN, IEEE v2.5, or Auto (port
auto-configures to use the DCBX version received from a peer).
Peer Operating version DCBX version that the peer uses to exchange DCB parameters.
Local DCBX TLVs
Transmitted
Transmission status (enabled or disabled) of advertised DCB TLVs (see TLV code
at the top of the show command output).
Local DCBX Status:
DCBX Operational
Version
DCBX version advertised in Control TLVs.
Local DCBX Status:
DCBX Max Version
Supported
Highest DCBX version supported in Control TLVs.
Local DCBX Status:
Sequence Number
Sequence number transmitted in Control TLVs.
Local DCBX Status:
Acknowledgment
Number
Acknowledgement number transmitted in Control TLVs.
Local DCBX Status:
Protocol State
Current operational state of the DCBX protocol: ACK or IN-SYNC.
Peer DCBX Status:
DCBX Operational
Version
DCBX version advertised in Control TLVs received from the peer device.
Peer DCBX Status:
DCBX Max Version
Supported
Highest DCBX version supported in Control TLVs received from the peer device.
Peer DCBX Status:
Sequence Number
Sequence number transmitted in Control TLVs received from the peer device.
Peer DCBX Status:
Acknowledgment
Number
Acknowledgement number transmitted in Control TLVs received from the peer
device.
Total DCBX Frames
transmitted
Number of DCBX frames sent from the local port.
Total DCBX Frames
received
Number of DCBX frames received from the remote peer port.
Total DCBX Frame errors Number of DCBX frames with errors received.
Total DCBX Frames
unrecognized
Number of unrecognizable DCBX frames received.
Table 9-2. show interface dcbx detail Command Example Fields (continued)
Field Description
To Next Page
Loading...
