Dell Force10 MXL Blade - Page 376

376 | Multiple Spanning Tree Protocol (MSTP)
www.dell.com | support.dell.com
Parameters
Defaults
default bridge-priority is 32768
Command Modes
INTERFACE
Command
History
Usage
Information
By default, all VLANs are mapped to MST instance zero (0) unless you use the vlan range command
to map it to a non-zero instance.
Although MSTP instance IDs range from 0 to 4094, only 64 active instances are supported on the
switch.
name
The name you assign to the multiple spanning tree region.
Syntax
name region-name
To remove the region name, use the no name command.
Parameters
Defaults
none
Command Modes
MULTIPLE SPANNING TREE
Command
History
Usage
Information
For two MSTP switches to be within the same MSTP region, the switches must share the same region
name (including matching case).
Related
Commands
msti instance
Enter the MST instance number.
Range: 0 to 4094.
vlan range
Enter the keyword vlan followed by the identifier range value.
Range: 1 to 4094
bridge-priority priority
Enter the keyword bridge-priority followed by a value in increments of
4096 as the bridge priority.
Range: zero (0) to 61440
Valid priority values are: 0, 4096, 8192, 12288, 16384, 20480, 24576,
28672, 32768, 36864, 40960, 45056, 49152, 53248, 57344, and 61440. All
other values are rejected.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
region-name
Enter the MST region name.
Range: 32 character limit
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
msti Maps the VLAN(s) to an MST instance.
revision Assigns the revision number to the MST configuration.