Dell Force10 MXL Blade - Page 405

Open Shortest Path First (OSPFv2) | 405
The default keyword sets all interfaces as passive. You can then configure individual interfaces, where
adjacencies are desired, using the no passive-interface interface command. The no form of this
command is inserted into the configuration for individual interfaces when the no passive-interface
interface command is issued while passive-interface default is configured.
This command behavior has changed as follows:
passive-interface interface
• The previous no passive-interface interface is removed from the running configuration.
• The ABR status for the router is updated.
• Save
passive-interface interface into the running configuration.
passive-interface default
• All present and future OSPF interface are marked as passive.
• Any adjacency are explicitly terminated from all OSPF interfaces.
• All previous
passive-interface interface commands are removed from the running
configuration.
• All previous no passive-interface interface commands are removed from the running
configuration.
no passive-interface interface
• Remove the interface from the passive list.
• The ABR status for the router is updated.
• If passive-interface default is specified, then save no passive-interface interface into the
running configuration.
No passive-interface default
• Clear everything and revert to the default behavior.
• All previously marked passive interfaces are removed.
• May update ABR status.
redistribute
Redistribute information from another routing protocol throughout the OSPF process.
Syntax
redistribute {connected | rip | | ospf | static} [metric metric-value | metric-type type-value]
[route-map map-name] [tag tag-value]
To disable redistribution, use the no redistribute {connected | ospf | rip | static} command.
Parameters
connected Enter the keyword connected to specify that information from active routes
on interfaces is redistributed.
rip Enter the keyword rip to specify that RIP routing information is redistributed.
ospf Enter the keyword ospf to specify that RIP routing information is redistributed.
static Enter the keyword static to specify that information from static routes is
redistributed.
metric metric-value (OPTIONAL) Enter the keyword metric followed by a number.
Range: 0 (zero) to 16777214.