Dell Force10 MXL Blade - Page 450

450 | Per-VLAN Spanning Tree Plus (PVST+)
www.dell.com | support.dell.com
Related
Commands
description
Enter a description of the PVST+
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
Defaults
No default behavior or values
Command Modes
SPANNING TREE PVST+ (The prompt is “config-pvst”)
Command
History
Related
Commands
edge-port bpdufilter default
Enable BPDU Filter globally to filter transmission of BPDU on port fast enabled interfaces.
Syntax
edge-port bpdufilter default
To disable global bpdu filter default, use the no edge-port bpdufilter default command.
Defaults
Disabled
Command Modes
CONFIGURATION (The prompt is “config-pvst”.)
Command
History
protocol spanning-tree pvst Enter PVST+ mode.
description
Enter a description to identify the Spanning Tree (80 characters maximum).
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
protocol spanning-tree pvst Enter SPANNING TREE mode on the switch.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module