Dell Force10 MXL Blade - Page 486

486 | Quality of Service (QoS)
www.dell.com | support.dell.com
Example
Figure 25-10. show qos wred-profile Command Example
test cam-usage
Check the Input Policy Map configuration for the CAM usage.
Syntax
test cam-usage service-policy input policy-map stack-unit {[number] | [all]}
Parameters
Defaults
none
Command Modes
EXEC
Command
History
Example
Figure 25-11. test cam-usage service-policy input policy-map stack-unit all Command
Example
FTOS#show qos wred-profile
Wred-profile-name min-threshold max-threshold
wred_drop 0 0
wred_ge_y 1024 2048
wred_ge_g 2048 4096
wred_teng_y 4096 8192
wred_teng_g 8192 16384
WRED1 2000 7000
policy-map
Enter the policy map name.
stack-unit number
(OPTIONAL) Enter the keyword stack-unit followed by the stack-unit
number.
stack-unit all (OPTIONAL) Enter the keywords stack-unit all to indicate all stack
units.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS# test cam-usage service-policy input pmap_l2 stack-unit all
For a L2 Input Policy Map pmap_l2, the output must be as follows,
Stack-unit Status| Portpipe | CAM Partition | Available CAM | Estimated CAM| Status
| | | | per Port | (Allowed ports)
0 0 L2ACL 500 200 Allowed (2)
0 1 L2ACL 100 200 Exception
1 0 L2ACL 1000 200 Allowed (5)
1 1 L2ACL 0 200 Exception
…
…
…
13 1 L2ACL 400 200 Allowed (2)
FTOS#
Note: In a Layer 2 Policy Map, IPv4 rules are not allowed and hence the output contains only
L2ACL CAM partition entries.