Dell Force10 MXL Blade - Page 521

Rapid Spanning Tree Protocol (RSTP) | 521
Parameters
Defaults
none
Command Modes
SPANNING TREE (The prompt is “config-rstp”.)
Command
History
Related
Commands
disable
Disable RSTP globally on the system.
Syntax
disable
To enable rapid spanning tree protocol, use the no disable command.
Defaults
RSTP is disabled
Command Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
Related
Commands
forward-delay
Configure the amount of time the interface waits in the Listening State and the Learning State before
transitioning to the Forwarding State.
Syntax
forward-delay seconds
To return to the default setting, use the no forward-delay command.
Parameters
Defaults
15 seconds
Command Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
description
Enter a description to identify the Rapid Spanning Tree (80 characters maximum).
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
protocol spanning-tree rstp Enters SPANNING TREE mode on the switch.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
protocol spanning-tree rstp Enters Rapid Spanning Tree mode
seconds
Enter the number of seconds that FTOS waits before transitioning RSTP to the forwarding
state.
Range: 4 to 30
Default: 15 seconds
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module