Dell Force10 MXL Blade - Page 54

54 | Control and Monitoring
www.dell.com | support.dell.com
Defaults
See parameters above.
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
When you enter the ping command without specifying an IP address (Extended Ping), you are
prompted for a target IP address, a repeat count, a datagram size (up to 1500 bytes), a timeout in
seconds, and for Extended Commands. For information on the ICMP message codes that return from a
ping command, refer to Appendix , .
Figure 4-7. ping (IPv4) Command Example
reload
Reboot FTOS.
Syntax
reload
Command Modes
EXEC Privilege
Command
History
sweep-interval
Enter the incremental value for sweep size.
1-15308 seconds
ointerface
Enter the outgoing interface for multicast packets.
• Enter the IP address in A.B.C.D format
• For a Port Channel, enter the keyword port-channel followed by a number:
1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1 to
4094.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#ping 172.31.1.255
Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 172.31.1.255, timeout is 2 seconds:
Reply to request 1 from 172.31.1.208 0 ms
Reply to request 1 from 172.31.1.216 0 ms
Reply to request 1 from 172.31.1.205 16 ms
:
:
Reply to request 5 from 172.31.1.209 0 ms
Reply to request 5 from 172.31.1.66 0 ms
Reply to request 5 from 172.31.1.87 0 ms
FTOS#
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module