Dell Force10 MXL Blade - Page 592

592 | Simple Network Management Protocol (SNMP) and Syslog
www.dell.com | support.dell.com
Defaults
As above
Command Modes
CONFIGURATION
Command
History
Usage
Information
No default values exist for authentication or privacy algorithms and no default password exist. If you
forget a password, you cannot recover it; the user must be reconfigured. You can specify either a
plain-text password or an encrypted cypher-text password. In either case, the password will be stored
in the configuration in an encrypted form and displayed as encrypted in the show running-config
command.
If you have an encrypted password, you can specify the encrypted string instead of the plain-text
password. Figure 31-9 shows how to specify the command with an encrypted string.
Examples
Figure 31-9. snmp-server user Command Example (Encrypted)
udp-port port-number
Enter the keyword udp-port followed by the UDP (User Datagram Protocol)
port number on the remote device.
Range: 0 to 65535.
Default: 162
1 | 2c | 3
(OPTIONAL) Enter the security model version number (1, 2c, or 3).
•
1 is the least secure version
•
3 is the most secure of the security modes.
•
2c allows transmission of informs and counter 64, which allows for integers
twice the width of what is normally allowed.
Default:
1
encrypted (OPTIONAL) Enter the keyword encrypted to specify the password appear in
encrypted format (a series of digits, masking the true characters of the string).
auth (OPTIONAL) Enter the keyword auth to specify authentication of a packet
without encryption.
md5 | sha
(OPTIONAL) Enter the keyword md5 or sha to designate the authentication
level.
md5 — Message Digest Algorithm
sha — Secure Hash Algorithm
auth-password
(OPTIONAL) Enter a text string (up to 20 characters long) password that will
enable the agent to receive packets from the host.
Minimum: 8 characters long
priv des56
(OPTIONAL) Enter the keyword priv des56 to initiate a privacy authentication
level setting using the CBC-DES privacy authentication algorithm (
des56).
priv password
(OPTIONAL) Enter a text string (up to 20 characters long) password that will
enables the host to encrypt the contents of the message it sends to the agent.
Minimum: 8 characters long
access-list-name
(OPTIONAL) Enter the standard IPv4 access list name (a string up to 16
characters long).
access-list-name
(OPTIONAL) Enter an IPv4 access list name.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS# snmp-server user privuser v3group v3 encrypted auth md5
9fc53d9d908118b2804fe80e3ba8763d priv des56 d0452401a8c3ce42804fe80e3ba8763d