Dell Force10 MXL Blade - Page 614

614 | Stacking Commands
www.dell.com | support.dell.com
Example
Figure 33-2. show redundancy Command Example
Related
Commands
show system stack-ports
Display information about the stacking ports on all switches in the MXL 10/40GbE switch stack.
Syntax
show system stack-ports [status | topology]
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
FTOS#show redundancy
-- Stack-unit Status --
------------------------------------------------
Mgmt ID: 0
Stack-unit ID: 0
Stack-unit Redundancy Role: Primary
Stack-unit State: Active
Stack-unit SW Version: E8-3-16-160
Link to Peer: Down
Peer Stack-unit: not present
-- Stack-unit Redundancy Configuration --
------------------------------------------------
Primary Stack-unit: mgmt-id 0
Auto Data Sync: Full
Failover Type: Hot Failover
Auto reboot Stack-unit: Enabled
Auto failover limit: 3 times in 60 minutes
-- Stack-unit Failover Record --
------------------------------------------------
Failover Count: 0
Last failover timestamp: None
Last failover Reason: None
Last failover type: None
-- Last Data Block Sync Record: --
------------------------------------------------
Stack Unit Config: no block sync done
Start-up Config: no block sync done
Runtime Event Log: no block sync done
Running Config: no block sync done
ACL Mgr: no block sync done
LACP: no block sync done
STP: no block sync done
SPAN: no block sync done
FTOS#
redundancy disable-auto-reboot Prevents the system from auto-rebooting if it fails.
status (OPTIONAL) Enter the keyword status to display the command output without the
Connection field.
topology (OPTIONAL) Enter the keyword topology to limit the table to just the Interface and
Connection fields.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module