Dell Force10 MXL Blade - Page 623

Spanning Tree Protocol (STP) | 623
disable
Disable the spanning tree protocol globally on the switch.
Syntax
disable
To enable STP, use the no disable command.
Defaults
Enabled (that is, the spanning tree protocol is disabled.)
Command Modes
SPANNING TREE
Command
History
Related
Commands
forward-delay
The amount of time the interface waits in the Listening State and the Learning State before
transitioning to the Forwarding State.
Syntax
forward-delay seconds
To return to the default setting, use the no forward-delay command.
Parameters
Defaults
15 seconds
Command Modes
SPANNING TREE
Command
History
Related
Commands
hello-time
Set the time interval between generation of the spanning tree bridge protocol data units (BPDUs).
Syntax
hello-time seconds
To return to the default value, use the no hello-time command.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
portfast bpdufilter default Enters SPANNING TREE mode.
seconds
Enter the number of seconds the FTOS waits before transitioning STP to the
forwarding state.
Range: 4 to 30
Default: 15 seconds.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
max-age Changes the wait time before STP refreshes protocol configuration information.
hello-time Changes the time interval between BPDUs.