Fujitsu Oracle SPARC M12-2 User Manual

Note -
Some FRUs such as memory do not have mounted LEDs. To check the status of a FRU
without a mounted LED, use an XSCF command such as the showhardconf command. For
details, see "(3) Checking the FRU status" below.
XSCF>
showlogs monitor
Jan 27 18:42:11 H4U2S115 Event: SCF:System powered on
Jan 27 18:45:41 H4U2S115 Event: SCF:PPAR-ID 0: Reset released
Jan 27 18:45:48 H4U2S115 Event: SCF:POST boot start from PPAR (PPAR ID 0)
Jan 27 18:45:49 H4U2S115 Event: SCF:Current PPARs' phase (PPARID 0 POST phase:
Banner)
Jan 27 18:45:50 H4U2S115 Event: SCF:Current PPARs'
phase (PPARID 0 POST phase:
CPU Check)
Jan 27 18:45:51 H4U2S115 Event: SCF:Current PPARs' phase (PPARID 0 POST phase:
CPU Register)
Jan 27 18:45:52 H4U2S115 Event: SCF:Current PPARs' phase (PPARID 0 POST phase:
STICK Increment)
Jan 27 18:45:53 H4U2S115 Event: SCF:Current PPARs' phase (PPARID 0 POST phase:
Extended Instruction)
Jan 27 18:45:54 H4U2S115
Event: SCF:Current PPARs' phase (PPARID 0 POST phase:
MMU)
Jan 27 18:46:07 H4U2S115 Event: SCF:Current PPARs' phase (PPARID 0 POST phase:
Memory Initialize)
Jan 27 18:46:43 H4U2S115 Event: SCF:Current PPARs' phase (PPARID 0 POST phase:
MSCAN)
You can check the system status from the LEDs on the OPNL. For details, see
"2.4.1 OPNL LEDs."
■
Rear panel LEDs
As with the CHECK LED on the OPNL, you can also check the system status from
the CHECK LED on the rear of the SPARC M12-2/M12-2S. For details, see "2.4.2
System Locator."
■
LEDs of individual FRUs
From the FRU LEDs, you can locate not only any error occurrence in hardware in
the SPARC M12-2/M12-2S but also the hardware that caused the error. For details,
see "2.4.3 LEDs of Each Unit."
(2) Checking error messages
If a failure occurs in the system, analyze the failure cause from the failure occurrence
time, abnormal event, and other data obtained from XSCF log information and
Oracle Solaris messages.
Checking XSCF log information
The following example shows a check of system operation and failure information
from XSCF log information. For details, see "12.1 Checking a Log Saved by the
XSCF" in the Fujitsu SPARC M12 and Fujitsu M10/SPARC M10 System Operation and
Administration Guide.
■
Checking monitoring messages
Fujitsu SPARC M12-2/M12-2S Service Manual
･
January 2023250

Fujitsu Oracle SPARC M12-2 Specifications

General

Brand	Fujitsu
Model	Oracle SPARC M12-2
Category	Server
Language	English