Fujitsu Oracle SPARC M12-2

2
1
1
Figure 21-4
Removing the Power Cord
4.
Remove the XSCF DUAL control cable.
Pull out the XSCF DUAL control cable (in the direction of arrow 2 in Figure 21-5)
while pushing in the latches on both sides of the cable connector (in the
directions of the arrows marked 1 in Figure 21-5
).
Figure 21-5
Removing the XSCF DUAL Control Cable (SPARC M12-2S)
Chapter 21 Maintaining the XSCF DUAL Control Cable 513