Hach sc200 - Page 121

Increasing Contact Life Span . . . . . . . . . . . . . . . . . . . .4-6
Figure 4-3. Relay Outputs . . . . . . . . . . . . . . . . . . . .4-6
Transistor Outputs . . . . . . . . . . . . . . . . . . . . . . . . . . . .4-7
Figure 4-4. Increasing Contact Life Span . . . . . . . .4-7
Figure 4-5. Transistor Outputs . . . . . . . . . . . . . . . . .4-8
Table 4-1. Snap-in I/O Module
Technical Specifications . . . . . . . . . . . . . . . . .4-9
Chapter 5,
Communications . . . . . . . . . . . . . . . . . . . . . . .5-1
RS232 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-1
Figure 5-1. RS232 Port Printout . . . . . . . . . . . . . . .5-1
Chapter 6,
Operating Instructions . . . . . . . . . . . . . . . . . .6-1
Power up Screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6-1
Figure 6-1. Power-up Screen . . . . . . . . . . . . . . . . . .6-1
Main Menu Screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6-2
Table 6-1. Keypad Functions . . . . . . . . . . . . . . . . .6-2
Figure 6-2. Main Menu Screen . . . . . . . . . . . . . . . .6-2
F1-Add Units to Network . . . . . . . . . . . . . . . . . . . . . . .6-3
Figure 6-3. Password Entry . . . . . . . . . . . . . . . . . . .6-3
Figure 6-4. Add Units to the Network . . . . . . . . . . .6-4
Screen Displaying Node IDs Found . . . . . . . . . . . . . .6-5
Figure 6-5. Node IDs Found . . . . . . . . . . . . . . . . . .6-5
F2-Add Unit Setpoints . . . . . . . . . . . . . . . . . . . . . . . . .6-6
Figure 6-6. Allows Users to Set Enabled or
Disabled Alarms . . . . . . . . . . . . . . . . . . . . . . .6-6
" WARNING . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6-6
Figure 6-7. Allows Users to Set Increasing or
Decreasing Alarms . . . . . . . . . . . . . . . . . . . . .6-7
Figure 6-8. Allows users to Set Latching /
Non-latching Alarms . . . . . . . . . . . . . . . . . . . .6-7
Figure 6-9. Allows Users to Assign Zone
Control Relays to Caution, Warning and
Alarm Setpoints for Sensors 1, 2, and 3 . . . .6-8
Figure 6-10. Current Set-point values
Read from the Selected Ultima X3 Unit . . . . .6-9
v