PAGE 30 PROGRAMMING REFERENCE
Relay Timer Timebase (Program Code 5.3)
Relay On Time (Program Code 5.3)
Relay Voice (Program Code 6)
Relay Special Functions (Program Code 5.3)
5. Telephone Specific Parameters
This section describes the parameters used when the unit is required to transmit alarms or signaling over the
telephone system.
Using Directory (Program Code 5.2)
Directory Telephone Numbers (Program Code 2)
Rings Before Answering (Program Code 4)
Dial Format (Program Code 6)
6. Radio Specific Parameters
These parameters control the operation of the unit when it is connected to a two-way radio. Refer to the installation
section in Getting Started for the required connections to the radio.
Directory Radio Command (Program Code 2)
Squelch Polarity (Program Code 6)
Radio Warmup (Program Code 2)
7. Expander Attachment
When an expander is added to the system, these parameters must be set. They configure the main B1290 unit to
accept the expander. The parameters within the expander must also be programmed. Refer to the Advanced
Programming Examples for an example of how this is done.
Number of Expanders (Program Code 7)
Site Voice Enable (Program Code 7)
8. Audio Levels
Audio Levels (Program Code 9)
To Next Page
Loading...
