Hach sc200 - Fault Status

F7- Fault Status
• Example of Diagnostic screen Identifying Unit ID and actual fault
on unit ID
• Fault screen will stay active after five minutes and then return to
the Main Menu screen. User can also press ESC to return to the
Main Menu screen.
• The ModCon 75 will display the following Ultima X3 sensor faults:
•+ LOC
• Over-range
• Quick under-range
• Under-range
• Sensor missing
• Sensor End of Life
• Calibration fault
• Power Fail fault
• Configuration reset
• All other faults are shown as General Fault
Figure 6-21. Fault Status
6-17