Name: Hach sc200
Brand: Hach
Rating: 5 (1 reviews)

To Next Page

To Previous Page

6. Locate the span gas cylinder and Calibration Kit Flow Controller.

7. Screw the Flow Controller onto the top of the span gas cylinder.

8. Locate the Calibration Kit Tube Assembly.

9. Push the smaller end of the Tube Assembly over the gas outlet of

the Flow Controller and ensure that the tubing completely covers

the gas outlet.

10.When using:

a. Cal Kit 40: connect the other end of the tubing over the

SensorGard inlet (FIGURE 2-6).

b. Cal Kit 41 (or Cal Kit 40 with the Ultima XIR): locate the cal

cap with hole for tubing and push the tubing through the hole

in the bottom of the cap. Then, connect the end of the tubing

over the sensor inlet and push the calibration cap over the

entire sensor inlet (see FIGURE 2-8).

c. Cal Kit 54: Run HCL gas through the regulator and tubing for

five minutes before attempting a calibration.

11. Turn ON the gas flow by turning the flow controller knob.

• It is good practice to have all calibration components

previously assembled.

• Ensure that any calibration gases are applied during the

30-second countdown period.

• If CAL FAULT displays on the Ultima/Ultima X Series Gas

Monitor before the user is able to apply the gas, a stable gas

condition was reached, causing the unit to use a wrong

reading as a span indication.

• It is necessary to restart the calibration process to clear

this condition.

Figure 2-6. Span Set-up (Ultima unit shown)

2-14

Other manuals for Hach sc200

Questions and Answers:

Need help?

Do you have a question about the Hach sc200 and is the answer not in the manual?

General