Hach sc200 - Figure 142: Right Panel (Side View); Figure 143: Installing the Right Panel into the Rear Groove; Installation; Left and Right Panels

Model 6 Motor Control Centers 80459-641-01E
Appendix B—Non-Conductive Horizontal Bus Barrier Retrofit Kit 10/2012
© 1999–2012 Schneider Electric All Rights Reserved122
ENGLISH
Left and Right Panels
Installation NOTE: The horizontal bus barrier contains two identical panels with arrows
at the top. The “handle” on the left panel faces the front of the MCC section.
The “handle cavity” on the right panel faces the front of the MCC section
(see Figure 142).
1. Align the arrows on the right panel and top track as shown in Figure 143.
2. Lift the panel up into the rear groove of the top track.
3. Lower the panel into the rear groove of the bottom track.
4. Slide the panel to the far right.
5. Align the arrows on the left panel and top track.
6. Repeat Steps 2 and 3 using the left panel and front groove.
7. Slide the panel to the left until it locks (snaps) into place.
8. Verify that the barrier is completely closed by making sure that the wiring
compartment is isolated from the bus compartment.
Figure 142: Right Panel (Side View)
Figure 143: Installing the Right Panel into the Rear Groove
Wireway Area
Horizontal Bus Area
Horizontal bus barrier -
right panel
Handle
Rear groove
Front of section
Handle cavity
Front groove
Right panel
Snap
Top track
Endcap
Rear groove
Flange points away from MCC