PROGRAMMING REFERENCE PAGE 29
8. PROGRAMMING REFERENCE
The ProTalk Plus is capable of performing many functions other than those set by its default values. If you require
these extended capabilities, they are accessed through the program codes. If the default operation of the unit as
described in the Getting Started chapter of this manual is sufficient, then you may ignore this section.
This chapter organizes the programming parameters by their functions. See the chapter on Program Codes for
more detail on the use and meaning of the referenced parameters.
1. Alarm Announcement
This section identifies all of the parameters that determine WHAT is sent when an alarm occurs. By programming
these parameters, you may send voice, signaling, and paging tones.
Directory Used (Program Code 5.2)
Directories (Program Code 2)
Record Alarm Voices (Program Code 1.1)
Alarm On/Off Output Codes (Program Code 3.4)
Acknowledge Request (Program Code 6)
Speak Messages (Program Code 2)
2. Alarm Operation
This section identifies all of the parameters that determine WHEN an alarm will be announced. By programming
these parameters, you control when an alarm is recognized and announced by the ProTalk Plus.
Alarm Format (Program Code 5.1)
Alarm Delay Timebase (Program Code 5.1)
Alarm Debounce (Program Code 5.1)
Interval Timer A (Program Code 4)
Interval Timer B (Program Code 4)
Cycles Through Timer A (Program Code 4)
3. Operation Codes
These parameters control how the unit operates. When one of these codes is received, the B1290 performs the
required function.
Acknowledge Code (Program Code 3.1)
Access Code (Program Code 3.2)
Interrogate Code (Program Code 3.6)
Remote Alarm Input Code (Program Code 3.5)
Directory Control Code (Program Code 3.7)
Access Code (Program Code 3.2)
4. Relay Control
The parameters required to control a relay are listed here. You may use any number of relays, but the ON/OFF input
codes, voice message and relay ON time must be programmed for each relay used. The relay voice code enables or
disables the voice confirmation for all relays.
Relay ON/OFF Control Codes (Program Code 3.3)
Record Relay Voices (Program Code 1.2)
To Next Page
Loading...
