Hach sc200 - Add Units to the Network

• F14 Populate registry
• F15 Stop pinging
• F6 View registry list
• F13 Keep old setpoints
• Press ESC- to go back to Main Menu Screen or F6 to view results.
NOTE: If changes are made to individual X
3
units through the use of
the Ultima Controller, user must run F14 to repopulate the
registry. Populating the registry will change the setpoints in the
ModCon75 Controller to match the setpoints and configuration
of all sensors on the network.
Figure 6-4. Add Units to the Network
6-4