Model 6 Motor Control Centers 80459-641-01E
Appendix B—Non-Conductive Horizontal Bus Barrier Retrofit Kit 10/2012
© 1999–2012 Schneider Electric All Rights Reserved120
ENGLISH
Follow the steps below to install the endcaps (see Figure 139).
1. Rivet one endcap into place on the retrofit bracket or the side channel,
either to the right or left side of the structure.
2. Insert one end of the top track into the attached endcap.
3. Place the other endcap on the opposite end of the top track, and slide
the top track into place.
4. Rivet the second endcap to the retrofit bracket.
Figure 138: 20 in. (508 mm) Deep MCC Retrofit Bracket
Topshelf
Top retrofit bracket
Screw
(1/4 x 20 x 1/2 in.)
Side channel
Figure 139: Endcap Placement
Rivets
Detail
Endcap
Top retrofit
bracket
See Detail
Side channel
Topshelf
To Next Page
Loading...
