Name: Hach sc200
Brand: Hach
Rating: 5 (1 reviews)

To Next Page

To Previous Page

UPS MAINTENANCE

Eaton

9130 UPS (700–3000 VA) User's Guide S 164201718 Rev 3 www.eaton.com/powerquality

5. For each cable retention clip removed, rotate the clip and install it

under each EBM cable connection using the retained screws.

6. Verify that the EBM connections are tight and that adequate bend

radius and strain relief exist for each cable.

Testing New Batteries

To test new batteries:

1. Plug the UPS into a power outlet for 48 hours to charge the

batteries.

2. Press any button to activate the menu options.

3. Select CONTROL then START BATTERY TEST.

The UPS starts a battery test if the batteries are fully charged, the

UPS is in Normal mode with no active alarms, and the bypass

voltage is acceptable.

During the battery test, the UPS transfers to Battery mode and

discharges the batteries for 25 seconds. The front panel displays

“Battery test running” and the percentage of the test completed.

Other manuals for Hach sc200

Questions and Answers:

Need help?

Do you have a question about the Hach sc200 and is the answer not in the manual?

General