EasyManuals Logo

Hach sc200 User Manual

Hach sc200
875 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #207 background imageLoading...
Page #207 background image
format (e.g.: 4:00 P.M. = 16:00). (Leading zeros are required.)
a. If your entry is valid, press ENTER button to save this time.
b. If your entry is invalid, it will not be accepted; re-enter the
correct time or press the CLEAR button to cancel
and start over.
• The DEL button allows for correction during entry.
Setting the Internal DATE of the Controller
NOTE: Momentarily pressing the DATE button displays the
current date.
1. Place unit in the READY mode.
• Display prompts: "ULTIMA READY" or "ULTIMAX READY".
2. Press and hold the DATE button until the MM-DD-YYYY prompt
appears. (Leading zeros are required.)
3. Enter the current date using the NUMBER buttons.
a. If your entry is valid, press ENTER button to save that date.
b. If your entry is invalid, it will not be accepted; re-enter date
or press the CLEAR button to cancel and start this
procedure again.
• The DEL button allows for correction during entry.
When Sending a Command
to the Ultima/Ultima X Series Gas Monitor
1. The Controller must be READY prior to any key press.
2. To change any function on the Ultima/Ultima X Series Gas Monitor,
point the top of the controller directly at the clear face of the sensor
(FIGURE 1-2) and press the desired sequence of controller
buttons. (The controller must be pointed at the sensor when the
final button of sequence is pressed.)
The top surface of the controller must be within six inches of
the sensor face to enable reception
Each button pressed is acknowledged by a short beep
• The CLEAR button is acknowledged by a double beep
When invalid responses are entered, the controller resets
to the READY mode or re-prompts user for a correct entry.
Note on Resetting latched Alarms
When an Ultima/Ultima X Gas Monitor has an active latched alarm
1-6

Table of Contents

Other manuals for Hach sc200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hach sc200 and is the answer not in the manual?

Hach sc200 Specifications

General IconGeneral
Enclosure RatingNEMA 4X/IP66
Operating Temperature-20 to 60 °C (-4 to 140 °F)
Ambient Temperature-20 to 60 °C (-4 to 140 °F)
Enclosure MaterialPolycarbonate
Operating Humidity0 to 95% non-condensing
Relay OutputsUp to 4 SPDT relays
Storage Conditions-40 to 70 °C (-40 to 158 °F)
DisplayGraphical LCD
Inputs2 digital sensor inputs
Outputs4-20 mA
Power Supply100 to 240 VAC, 50/60 Hz
Analog Outputs2 or 4, 0/4-20 mA
CertificationsCE
CommunicationModbus RTU, HART
Dimensions144 x 144 mm
MountingPanel mount
Output4-20 mA
Power Requirements (Voltage)100 to 240 VAC
Warranty1 year
Weight1.2 kg

Related product manuals