Name: Hach sc200
Brand: Hach
Rating: 5 (1 reviews)

To Next Page

To Previous Page

4. Press the ENTER button.

• The display prompts: CalHour HH.

5. Enter the two-digit hour desired

(from 0 to 23 hours YPM = 16 hours). (Leading zero is required.)

6. Aim the controller at the sensor and press the ENTER button.

• The Ultima Gas Monitor displays the hour selected

• The Ultima Gas Monitor is now programmed to auto-calibrate

at the desired time.

Procedure 10. Setting the Date of the

Next Scheduled Ultima Gas Monitor Calibration

To disable the auto-calibration of the Ultima Gas Monitor, set the date of

the next calibration to 12/31/94.

1. Press the SEND button.

• The display prompts: SEND?

2. Press the CAL button.

• The display prompts: Sel Cal Action +

3. Press either the + or - button and scroll to the NextCal Date

display message.

4. Press the ENTER button.

• The display prompts: MM-DD YYYY.

5. Enter a valid eight-digit date (month-day-year).

6. Aim the controller at the sensor and press the ENTER button.

(Leading zeros are required.)

• The Ultima Gas Monitor displays the future date

auto-calibration will start

• The Ultima Gas Monitor is now programmed to auto-calibrate

on the desired date.

Procedure 11. Changing the MUX Address

1. Viewing the current Mux Address, aim the Controller at the Ultima

Gas Monitor.

2. Press the ADDRESS button.

• The current address of the sensor displays.

NOTE: Additional pressing of the ADDRESS button increments

the address.

3-14

Other manuals for Hach sc200

Questions and Answers:

Need help?

Do you have a question about the Hach sc200 and is the answer not in the manual?

General