Name: Hach sc200
Brand: Hach
Rating: 5 (1 reviews)

To Next Page

To Previous Page

UPS MAINTENANCE

Eaton

9130 UPS (700–3000 VA) User's Guide S 164201718 Rev 3 www.eaton.com/powerquality

S Do not open or mutilate the battery or batteries. Released electrolyte is harmful to the

skin and eyes and may be extremely toxic.

S Determine if the battery is inadvertently grounded. If inadvertently grounded, remove

source from ground. Contact with any part of a grounded battery can result in electrical

shock. The likelihood of such shock can be reduced if such grounds are removed during

installation and maintenance (applicable to equipment and remote battery supplies not

having a grounded supply circuit).

S ELECTRIC ENERGY HAZARD. Do not attempt to alter any battery wiring or connectors.

Attempting to alter wiring can cause injury.

S Disconnect charging source prior to connecting or disconnecting battery terminals.

Replacing Rackmount UPS Internal Batteries

C A U T I O N

The UPS internal batteries are heavy (see page 78). Use caution when handling the heavy

batteries.

The internal batteries are located behind the UPS right front cover

(behind the LCD control panel). The internal batteries are packaged

together as one unit for easier handling.

To replace the batteries in the UPS:

1. Remove the UPS right front cover (see Figure 23).

To remove the cover, remove and retain the two screws on the

right side of the cover. Grasp the top and bottom of the cover and

slide the cover to the right.

NOTE A ribbon cable connects the LCD control panel to the UPS. Do not pull on the cable

or disconnect it.

Other manuals for Hach sc200

Questions and Answers:

Need help?

Do you have a question about the Hach sc200 and is the answer not in the manual?

General