Model 6 Motor Control Centers 80459-641-01E
Section 6—Maintaining the MCC 10/2012
© 1999–2012 Schneider Electric All Rights Reserved60
ENGLISH
11. If necessary, the door can be taken off its hinges without removing the
unit. To do so, drive the hinge pins out of the hinge collars, using a small
flat-bladed screwdriver or small punch (see Figure 83). Remove the
bottom hinge pin first.
As an alternative to removing the hinge pins, the hinge mounting screws
can be removed from the structure through the access holes provided.
12. When reinstalling a hinge pin, make certain that the hooked end is fully
engaged into the hinge collar.
Removing the Compac™ 6
Control Unit
The following information is specific to Compac 6, six-inch (52 mm) units.
For more information regarding Compac 6 units, refer to “Compac™ 6
Units” beginning on page 97, or the information included with the shipment
of the new device.
1. Turn off all power supplying this equipment before working on or inside the
equipment, and follow lockout/tagout procedures. Always use a properly
rated voltage sensing device to confirm power is off.
2. Move the operator handle to the OFF position (see Figure 84 on page 61).
Figure 83: Driving Out Hinge Pin
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Apply appropriate personal protective equipment (PPE) and follow safe
electrical work practices. See NFPA 70E or CSA Z462.
• This equipment must only be installed and serviced by qualified
electrical personnel.
• Turn off all power supplying this equipment before working on or inside it.
• Always use a properly rated voltage sensing device to confirm power is off.
• Replace all devices, doors, and covers before turning on power to this
equipment.
Failure to follow this instruction will result in death or serious injury.
To Next Page
Loading...
