F3-Main Data Screen
• F1- Scrolls through all units on the Modbus network.
• F2- Allows one to view a specific unit.
• F3- Adjusts the scroll time reading each node.
Typical Display shows three sensors on the ModCon 75 Controller.
• "All Clear" - shows all three sensors are not in alarm.
• Box in lower-right corner shows ModBus network/sensor status.
• Current values are shown next to sensor number.
• ESC-Back to Main screen
Figure 6-17. All Clear Status Screen
Figure 6-16. Main Data Screen
6-13
To Next Page
Loading...
