Name: Hach sc200
Brand: Hach
Rating: 5 (1 reviews)

To Next Page

To Previous Page

80459-641-01E Model 6 Motor Control Centers

10/2012 Appendix B—Non-Conductive Horizontal Bus Barrier Retrofit Kit

119

ENGLISH

Install the Retrofit Kit

Retrofit Brackets and Endcaps Follow the applicable instructions below to install retrofit brackets into

15 in. (381 mm) or 20 in. (508 mm) deep MCCs. The top retrofit bracket

must sit flush against the side channel. Slide the black grommets toward the

back of the MCC.

• 15 in. (381 mm) deep MCC: Use a rivet gun and two rivets in the retrofit

kit to attach the retrofit brackets to the left and right side channels (see

Figure 137).

• 20 in. (508 mm) deep MCC: Use the screws provided in the retrofit kit to

attach the retrofit brackets to the left and right side channels. Align the

holes in the bracket and side channel as shown in Figure 138 on page

120.

NOTES: • Even if the holes are present for a direct mounting of the

endcap to the side channels, use the top retrofit bracket on

20 in. (508 mm) deep MCCs.

• Before tightening the screws, push the bracket away from

you so that the rear bracket hole is properly aligned with the

side channel hole.

Figure 137: 15 in. (381 mm) Deep MCC Retrofit Bracket

Top retrofit bracket

Topshelf

Side channel

Rivets

Other manuals for Hach sc200

Questions and Answers:

Need help?

Do you have a question about the Hach sc200 and is the answer not in the manual?

General