Hach sc200 - Different Alarms Dialing Different Telephone Numbers

PROGRAMMING EXAMPLES PAGE 35
YOU: Quit
B1290: Enter Directory
YOU: Quit
The telephone numbers have now been programmed. Now enter the Directory Control Code
B1290: Enter Program Code
YOU: DTMF Codes
B1290: Enter DTMF Code
YOU: Directory Control Code
B1290: Directory Control Code is...
YOU: Enter Control Code
B1290: Directory Control Code is 78
YOU:  Next
B1290: Enter Program Code
Right now the B1290 is programmed with dialing commands in Directory A and Directory B. Any alarms that
are to be switched between these two directories should be programmed to use Directory A or the control code
will have no effect. Each alarm has its own setting for the directory it is using. Make sure that the alarms you
want to have changed are set properly.
YOU: Select Configuration
B1290: Enter Configuration Code
YOU: Select Using Directory
B1290: Alarm One is Directory is...
YOU: Select Directory A
B1290: Alarm One is Directory is A
YOU:  Next
Repeat this for all of the alarms
When you wish to dial from the B directory, call up the B1290 and follow these steps:
B1290: Enter Control Code
YOU:  Directory Control Code
B1290: Telephone Format is Directory B
And to change it back:
B1290: Enter Control Code
YOU:  Directory Control Code
B1290: Telephone Format is Directory A
Example 3: Different Alarms Dialing Different Telephone Numbers
A B1290 is used in an application where there are two different types of related alarms. Some are building alarms,
such as intrusion alarms, building temperature, power failure, etc. Others are alarms relating to specific equipment
failures, such as compressor failure, high tank level or sump overflow. It is desirable to have the maintenance
personnel alerted if there is a building alarm, but if there is a problem with the equipment, it would be preferable to
alert the operations technicians.
In this example, alarms 1 and 2 are connected to intrusion alarm and building high temperature respectively. These
are building alarms, and are to dial the building maintenance people at 403-255-9544 and then 403-255-9598.