INSTALLATION
Eaton
®
9130 UPS (700–3000 VA) User's Guide S 164201718 Rev 3 www.eaton.com/powerquality
20
Rackmount Setup
C A U T I O N
S The cabinet is heavy (see page 78). Removing the cabinet from its carton requires a
minimum of two people.
S If installing optional EBM(s), install the EBM(s) directly below the UPS so that all wiring
between the cabinets is installed behind the front covers and is inaccessible to users.
NOTE Mounting rails are required for each individual cabinet.
To install the rail kit:
1. Assemble the left and right rails to the rear rails as shown in
Figure 4. Do not tighten the screws.
Adjust each rail size for the depth of your rack.
Rear Rails
Right Rail
Left Rail
M4
8 Pan-Head
Screws (6 places)
Figure 4. Assembling the Rails
To Next Page
Loading...
