Hach sc200 - Page 331

PROGRAMMING EXAMPLES PAGE 37
B1290: Enter Voice Code
YOU: Quit
B1290: Enter Program Code
YOU: Select DTMF Codes
B1290: Enter DTMF Code
YOU: Select Relay On and Off Codes
B1290: Relay One On Code is empty
YOU:  (pause) Enter On code
B1290: Relay One On Code is 555À
YOU:  Next
B1290: Relay One Off Code is empty
YOU: 
 Enter Off code
B1290: Relay One Off code is 555#
YOU:  Next
B1290: Relay Two On Code is empty
YOU:  Next
B1290: Relay Two Off Code is empty
And so on until all of the Relay Codes are done...
B1290: Enter DTMF Code
YOU:  Next
B1290: Enter Program Code
YOU: I/O Configuration
B1290: Enter Configuration Code
YOU: Next
B1290: Relay Timer is seconds
YOU: Select minutes for the timebase
B1290: Relay Timer is minutes
YOU:  Next
B1290: Relay One On Timer is 00 minutes
YOU: Select 10 minutes for the time
B1290: Relay One On is 10 minutes
YOU:  Next
B1290: Relay Two On timer is 00 minutes
At this time you are finished programming and can hang up the phone. When the B1290 calls you with an
alarm, the sequence will be as follows:
B1290: Ajax Compressor Station; High Pressure.
Enter Acknowledge Code