Hach sc200 - Page 334

PAGE 40 PROGRAMMING EXAMPLES
Starting with the timer setup:
B1290: Enter Program Code
YOU: 
B1290: Answer Rings is 4 (No effect on operation)
YOU:  Next
B1290: Timer A is 2 minutes
YOU: Change the timer to 1 minute
B1290: Timer A is 1 minutes
YOU:  Next
B1290: Timer B is 10 minutes
YOU: Change the timer to zero
B1290: Timer B is 0 minutes
YOU:  Next
B1290: Times A is 3
YOU: Change the times A to 2
B1290: Times A is 2
YOU:  Next
The timers are now set, now put the commands into the directory.
B1290: Enter Program Code
YOU: Directory Code
B1290: Enter Directory
YOU: Directory A
B1290: Directory A, Line One is...
YOU: Change
B1290: ‘beep’
YOU: 
[RADIO][ALERT][VOICE][VOICE]
B1290: Directory A, Line One is RADIO ALERT VOICE VOICE
YOU:  Next
B1290: Directory A, Line Two is..
YOU: Quit
B1290: Enter Directory
YOU: Quit
Now remove the acknowledge request prompt.
B1290: Enter Program Code
YOU: 
B1290: Dial Format is Zero
YOU:  Next