To Next Page

To Previous Page

Related commands

last-member-query-count (IGMP view)

igmp last-member-query-interval

Use igmp last-member-query-interval to set the IGMP last member query interval on an interface.

Use undo igmp last-member-query-interval to restore the default.

Syntax

igmp last-member-query-interval interval

undo igmp last-member-query-interval

Default

The IGMP last member query interval is 1 second.

Views

Interface view

Predefined user roles

network-admin

Parameters

interval: Sets an IGMP last member query interval in the range of 1 to 25 seconds.

Usage guidelines

This command and the last-member-query-interval command in IGMP view have the same function but

different effective ranges:

• The last-member-query-interval command in IGMP view takes effect on all interfaces.

• The igmp last-member-query-interval command takes effect on the current interface.

For an interface, the igmp last-member-query-interval command takes priority over the

last-member-query-interval command in IGMP view.

Examples

# Set the IGMP last member query interval to 6 seconds on VLAN-interface 100.

<Sysname> system-view

[Sysname] interface vlan-interface 100

[Sysname-Vlan-interface100] igmp last-member-query-interval 6

Related commands

last-member-query-interval (IGMP view)

igmp max-response-time

Use igmp max-response-time to set the maximum response time for IGMP general queries on an

interface.

Use undo igmp max-response-time to restore the default.

Syntax

igmp max-response-time time

Other manuals for HP 5900 series

Questions and Answers:

Need help?

Do you have a question about the HP 5900 series and is the answer not in the manual?

General