HP 5900 series Command Reference

[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping report source-ip fe80:0:0:1::1
Related commands
• enable (MLD-snooping view)
• mld-snooping enable
mld-snooping query-interval
Use mld-snooping query-interval to set the MLD general query interval in a VLAN.
Use undo mld-snooping query-interval to restore the default.
Syntax
mld-snooping query-interval interval
undo mld-snooping query-interval
Default
The MLD general query interval in a VLAN is 125 seconds.
Views
VLAN view
Predefined user roles
network-admin
Parameters
interval: Set an MLD general query interval, in the range of 2 to 31744 seconds.
Usage guidelines
You must enable MLD snooping for a VLAN before you execute this command for the VLAN.
To avoid mistakenly deleting IPv6 multicast group members, set the MLD general query interval to be
greater than the maximum response time for MLD general queries.
Examples
# In VLAN 2, enable MLD snooping, and set the MLD general query interval to 20 seconds.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping query-interval 20
Related commands
• enable (MLD-snooping view)
• max-response-time
• mld-snooping enable
• mld-snooping max-response-time
226

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)