HP 5900 series - Igmp-Snooping Router-Aging-Time

Related commands
• enable (IGMP-snooping view)
• igmp-snooping enable
igmp-snooping router-aging-time
t the aging timer for the dynamic router ports in a VLAN.
me to restore the default.
terval
undo igmp-snooping router-aging-time
Default
60 seconds.
Views
N view
Predefine
Usage guide
LAN.
The router-aging-time command in IGMP-snooping view takes effect on all VLANs.
N, the igmp-snooping router-aging-time command takes priority over the router-aging-time
g view.
Examples
ing, and set the aging timer for the dynamic router ports to 100
gmp-snooping] quit
ping enable
ing-time 100
Related c
• enable (IGMP-snooping view)
• igmp-snooping enable
Use igmp-snooping router-aging-time to se
Use undo igmp-snooping router-aging-ti
Syntax
igmp-snooping router-aging-time in
The default setting is 2
VLA
d user roles
network-admin
Parameters
interval: Sets an aging timer for the dynamic router ports in a VLAN, in the range of 1 to 8097894
seconds.
lines
You must enable IGMP snooping for a VLAN before you execute this command for the V
This command and the router-aging-time command in IGMP-snooping view have the same function but
different effective ranges:
•
• The igmp-snooping router-aging-time command takes effect on the current VLAN.
For a VLA
command in IGMP-snoopin
# In VLAN 2, enable IGMP snoop
seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-i
[Sysname] vlan 2
[Sysname-vlan2] igmp-snoo
[Sysname-vlan2] igmp-snooping router-ag
ommands
33