HP 5900 series Command Reference

Table 64 Command output
Field Descri
p
tion
general queries ueries. Number of MLD general q
specific queries specific queries. Number of MLD multicast-address-
reports Number of MLD reports.
dones Number of MLD done messages.
reports with right and wrong records Number of MLD reports with correct and incorrect records.
specific sg queries Number of MLD multicast-address-and-source-specific queries.
IPv6 PIM hello Number of IPv6 PIM hello messages.
error MLD messages Number of MLD messages with errors.
Related commands
reset mld-snooping statistics
dot1p
Use dot1p-priority to set the 802.1p priority for MLD messages globally.
ore the default.
Syntax
dot1p-priority priority-number
r MLD messages is not configured.
iew
ser roles
Paramete
mber: Sets an 802.1p priority for MLD messages, in the range of 0 to 7. A higher value means
Usage gu
tion but different
dot1p-priority command takes effect on the current VLAN.
r a VLAN, the mld-snooping dot1p-priority command takes priority over the dot1p-priority command
Examples
sages to 3 globally.
-priority (MLD-snooping view)
Use undo dot1p-priority to rest
undo dot1p-priority
Default
The 802.1p priority fo
Views
MLD-snooping v
Predefined u
network-admin
rs
priority-nu
a higher priority.
idelines
This command and the mld-snooping dot1p-priority command have the same func
effective ranges:
• The dot1p-priority command in MLD-snooping view takes effect on all VLANs.
• The mld-snooping
Fo
in MLD-snooping view.
# Set the 802.1p priority for MLD mes
205

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)