HP 5900 series Command Reference

Related commands
• igmp-snooping enable
g dot1p-priority
ing dot1p-priority to set the 802.1p priority for IGMP messages in a VLAN.
undo igmp-snooping dot1p-priority to restore the default.
Syntax
g dot1p-priority priority-number
Default
sages is not configured.
Views
Predefine
ue means
Usage gu
P snooping for a VLAN before you execute this command.
and in IGMP-snooping view have the same function but
t1p-priority command in IGMP-snooping view takes effect on all VLANs.
es effect on the current VLAN.
dot1p-priority command takes priority over the dot1p-priority
view.
t the 802.1p priority for IGMP messages to 3.
[Sysname] vlan 2
ng dot1p-priority 3
Related c
• dot1p-priority (IGMP-snooping view)
p-snooping enable
• enable (IGMP-snooping view)
igmp-snoopin
Use igmp-snoop
Use
igmp-snoopin
undo igmp-snooping dot1p-priority
The 802.1p priority for IGMP mes
VLAN view
d user roles
network-admin
Parameters
priority-number: Sets an 802.1p priority for IGMP messages, in the range of 0 to 7. A higher val
a higher priority.
idelines
You must enable IGM
This command and the dot1p-priority comm
different effective ranges:
• The do
• The igmp-snooping dot1p-priority command tak
For a VLAN, the igmp-snooping
command in IGMP-snooping
Examples
# In VLAN 2, enable IGMP snooping, and se
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snoopi
ommands
• enable (IGMP-snooping view)
• igm
19

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)