HP 5900 series Command Reference

Use undo multicast forwarding supervlan community to restore the default.
Syntax
multicast forwarding supervlan community
undo multicast forwarding supervlan community
Default
Multicast data cannot be forwarded among sub-VLANs of the super VLAN.
Views
VLAN interface view
Predefined user roles
network-admin
Usage guidelines
After you execute the multicast forwarding supervlan community command, you must clear all multicast
forwarding entries with the super VLAN interface as the incoming interface. Otherwise, this command
cannot take effect. To clear the required multicast forwarding entries, use the reset multicast
forwarding-table command.
Examples
# Configure multicast forwarding among sub-VLANs of the super VLAN 2.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] multicast forwarding supervlan community
Related commands
reset multicast forwarding-table
multicast routing
Use multicast routing to enable IP multicast routing and enter MRIB view.
Use undo multicast routing to disable IP multicast routing.
Syntax
multicast routing [ vpn-instance vpn-instance-name ]
undo multicast routing [ vpn-instance vpn-instance-name ]
Default
IP multicast routing is disabled.
Views
System view
Predefined user roles
network-admin
82

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)