HP 5900 series Command Reference

PIM snooping does not take effect on sub-VLANs of a multicast VLAN.
Examples
lobally, and enable IGMP snooping and PIM snooping for VLAN 2.
lan2] pim-snooping enable
Related c
pim-snooping graceful-restart join-aging-time
g global
ter election.
Use undo pim-snooping graceful-restart join-aging-time to restore the default.
Syntax
undo pim-snooping graceful-restart join-aging-time
Default
The default setting is 210 seconds.
Views
Predefine
ork-admin
Paramete
ets an aging time in the range of 210 to 18000 seconds.
Usage gu
global router port is a Layer 2 aggregate interface that acts as a
u must enable PIM snooping for a VLAN before you execute this command for the VLAN.
Examples
stream ports and global router ports to
aster device in IRF master election.
# Enable IGMP snooping g
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-v
ommands
• igmp-snooping
• igmp-snooping enable
Use pim-snooping graceful-restart join-aging-time to set the aging time for PIM snoopin
downstream ports and global router ports on the new master device in IRF mas
pim-snooping graceful-restart join-aging-time interval
VLAN view
d user roles
netw
rs
interval: S
idelines
A global downstream port or a
downstream port or router port.
Yo
# In VLAN 2, set the aging time for PIM snooping global down
600 seconds on the new m
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
51

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)