Predefined user roles
network-admin
Parameters
interval: Sets an MLD general query interval in the range of 1 to 31744 seconds.
Usage guidelines
This command and the mld query-interval command have the same function but different effective
ranges:
• The query-interval command in MLD view takes effect on all interfaces.
• The mld query-interval command takes effect on the current interface.
For an interface, the mld query-interval command takes priority over the query-interval command in
MLD view.
Examples
# Set the global MLD general query interval to 60 seconds on the public network.
<Sysname> system-view
[Sysname] mld
[Sysname-mld] query-interval 60
Related commands
mld query-interval
reset mld group
Use reset mld group to remove dynamic MLD group entries.
Syntax
reset mld [ vpn-instance vpn-instance-name ] group { all | interface interface-type interface-number { all
| ipv6-group-address [ prefix-length ] [ ipv6-source-address [ prefix-length ] ] } }
Views
User view
Predefined user roles
network-admin
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. If you do not specify a VPN instance, the command removes dynamic MLD group
entries on the public network.
all: The first all specifies all interfaces, and the second all specifies all MLD groups.
interface-type interface-number: Specifies an interface by its type and number.
ipv6-group-address: Specifies an IPv6 multicast group by its IPv6 address in the range of FFxy::/16,
where "x and "y" represent any hexadecimal numbers from 0 to F.
ipv6-source-address: Specifies an IPv6 multicast source by its IPv6 address. If you do not specify an IPv6
multicast source, the command removes dynamic MLD group entries of all IPv6 multicast source
addresses.
294
To Next Page
Loading...
Need help?
General
