HP 5900 series - Mld Static-Group

Parameters
interval: Sets an MLD startup query interval in the range of 1 to 31744 seconds.
Usage guidelines
This command and the startup-query-interval command in MLD view have the same function but
different effective ranges:
• The startup-query-interval command in MLD view takes effect on all interfaces.
• The mld startup-query-interval command takes effect on the current interface.
For an interface, the mld startup-query-interval command takes priority over the startup-query-interval
command in MLD view.
Examples
# Set the MLD startup query interval to 100 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mld startup-query-interval 100
Related commands
startup-query-interval (MLD view)
mld static-group
Use mld static-group to configure an interface as a static group member of an IPv6 multicast group.
Use undo mld static-group to restore the default.
Syntax
mld static-group ipv6-group-address [ source ipv6-source-address ]
undo mld static-group { all | ipv6-group-address [ source ipv6-source-address ] }
Default
An interface is not a static group member of IPv6 multicast groups.
Views
Interface view
Predefined user roles
network-admin
Parameters
ipv6-group-address: Specifies an IPv6 multicast group by its IPv6 address. The value range for this
argument is FFxy::/16 (excluding FFx0::/16, FFx1::/16, FFx2::/16, and FF0y::), where "x" and "y"
represent any hexadecimal numbers from 0 to F.
ipv6-source-address: Specifies an IPv6 multicast source. If you do not specify an IPv6 multicast source,
the command configures an interface as a static group member of the multicast groups with all IPv6
multicast source addresses.
all: Specifies all IPv6 multicast groups that the interface has statically joined.
291