HP 5900 series Command Reference

Related commands
• enable (IGMP-snooping view)
• igmp-snooping enable
• last-member-query-interval (IGMP-snooping view)
igmp-snooping leave source-ip
Use igmp-snooping leave source-ip to configure a source IP address for IGMP leave messages.
Use undo igmp-snooping leave source-ip to restore the default.
Syntax
undo igmp-snooping leave source-ip
Default
ess of IGMP leave messages is the IP address of the current VLAN interface. If the
terface does not have an IP address, the source IP address is 0.0.0.0.
les
Usage guide
ing for a VLAN before you execute this command.
Examples
onfigure 10.1.1.1 as the source IP address of IGMP leave
igmp-snooping
[Sysname-vlan2] igmp-snooping enable
10.1.1.1
-snooping enable
-snooping max-response-time
et the maximum response time for IGMP general queries in
Use undo igmp-snooping max-response-time to restore the default.
igmp-snooping leave source-ip ip-address
The source IP addr
current VLAN in
Views
VLAN view
Predefined user ro
network-admin
Parameters
ip-address: Specifies a source IP address for IGMP leave messages.
lines
You must enable IGMP snoop
# In VLAN 2, enable IGMP snooping, and c
messages.
<Sysname> system-view
[Sysname]
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping leave source-ip
Related commands
• enable (IGMP-snooping view)
• igmp
igmp
Use igmp-snooping max-response-time to s
a VLAN.
28

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)